Escalib Mills_GB

Assembling and dismantling... 6 E s C A L I B M I L L s M D s : s I T E s P I R A L s T A I R C A s E W I T H s I D E E X I T EsCALIB MILLs MDs > 1 - The base must be oriented according to the height of the floor which needs to be accesed. start the installation 8 cm away from the wall to facilitate pivoting of the guardrails at the access level. Level the base. > 2 - Access inside the module is available for attaching the sling to the center ring, for putting the guardrails in closed position and putting the erection rails in horizontal position. > 3 - Fit the module to the base. Assembly of the 4 uprights with M24 screws. sling released. > 4 - Instal a new module. > 5 - Erection guardrail rotated to vertical position and locked onto stair above. Bolt the uprights together using M24 screws. slings released. Repeat steps 2, 4 and 5 if needed while anchoring the Escalib as the height is increased. REQUIREMENTS: > Fit new anchorages as new modules are added. > Dismantle in the reverse order of assembly. Fixings: - Module and base: M24x35-8-8 hex head screw + washer. - Barrier gate: M16x100 hex head bolt I NTERMEDIATE MODULES Example of an Escalib Mills with 3 modules. N.B.: Check that the ground on which the staircase Escalib Mills is to be erected is able to withstand the load. N.B.: Comply with the general rules for handling and stability. ASTUCE start bolting with the new module’s first step (corner A-D) and then continue clockwise.